Is the water dispenser on your refrigerator broken? If not, you can attempt to solve the issue on your own or call IBC Irving Appliance Repair for refrigerator repair Irving, Texas.
There are several reasons for the water dispenser in a refrigerator to not work. Again, some suggestions might sound a little strange. However, something as obvious as a power switch has been the cause in the past. Be sure to inspect the obvious potential issues prior to moving forward with complicated refrigerator repair. Let’s start to tackle this appliance repair issue and see what solutions we can cite for a broken water dispenser on a refrigerator.
The cause of a water dispenser not working is commonly an installation issue, a filter failure or frozen water tubes:
You just bought a new refrigerator for your kitchen with a water dispenser, but it is not working. The water dispenser must be connected to the water line. That might be the reason for the issue.
If the brand new refrigerator is replacing a prior refrigerator that did not include an ice maker or water dispenser, there is a possibility that you do not have a functioning water line running to this area. Most of the time a water line is commonly run from underneath the house either in a crawl space or basement. You can acquire this line at nearly any home repair store and they’re very simple for even the average homeowner to install. Usually they have include a water shut-off valve, which is necessary so that if you ever need to move the refrigerator, you can shut off the water.
If you have a connected water line, is the valve on? The valve handle should be lined up with the hose. And, is there water running through the pipe that you have installed to connect the water line? Obvious and questions, but things that need to be accounted for.
If you had to remove the doors during installation it’s possible the water dispenser might not be plugged in. Review the owner’s manual to see the wire harness for the particular refrigerator. Check that it’s plugged into the refrigerator.
If the water is hooked up, most of the time there’s air in the line. So, lifting and lowering the water dispenser control to get the air out of it is needed.
On some refrigerators, there are various filters. These filters could “expire”, clog or freeze. All of the filters are dependent on your style and type of refrigerator. If the filter is blocked it can cause slow filling or no flowing. It is suggested that your filter is replaced every 6 months. Replacing filters can be challenging. If you run into issues, go online and find the right process to change a filter.
One suggestion is to fill up the filter with water before installing it. A lot of time the water filters take a long time to fill, which could lead you to think the water dispenser on the refrigerator isn’t working right. You should read the directions if all else fails. To ensure it’s not air caught in the lines, depress the dispenser lever for around 5 minutes.
A frozen water tank could be the reason for the problem as well in some models. If the tank is frozen it will leak onto the food bins. Limited food inside of the fresh food bins will cause freezing.
Copyright ©2020  IBC Irving Appliance Repair